Our “L” pole attaches to our pole and base system to hang banners or signs. Will raise pole by 24″ and accept a 34″ banner. Add pocket to your banner or attach with cable ties if it has grommets.
Must use appropriate ballast.
Dimensions: 32″ x 34″ with insert steel with silver powder coating
California Prop 65 | WARNING: Cancer and Reproductive Harm www.P65Warnings.ca.gov
Weight | 9 lbs |
---|
$337.00
+Shipping
Bracket holds up to 2 – 100lb Propane tanks, but can adjust down to hold smaller tanks. (BLOCK NOT INCLUDED) Add this Propane Tank/Cylinder Bracket kit to any Block And Roll® Block to safely store tanks and keep them from tipping over on hard surfaces that can’t be penetrated with a stake. Bracket can also […]
Learn More
$12.99
+Shipping
Includes: Custom threaded 1/2-13″ U-Bolt, 2- 1/2″ nuts and 2- 1/2″ washers Custom manufactured square U-bolt 3-1/2” inside length, 3-1/16” width between the legs, 3.0” of ½”-13 rolled thread, Zinc Finish
Learn More
$129.00
+Shipping
Pole Base 8 is a plate that gets bolted to your Block and Roll Blocks with the included U-Bolt. This will allow you to use your blocks with our Pole and Base System. Simply choose the block size based on the amount of weight needed. Includes: 1- 1/2″ U-Bolt, 2- 1/2″ nuts and 2- 1/2″ […]
Learn More
$149.00
+Shipping
Add this Propane Tank/Cylinder Bracket to any 2″ post or our Pole and Base System components to safely store tanks and keep them from tipping over. Add block post mount, 48″ post and Block And Roll® Block for free standing applications where ground penetration is not allowed/ Bracket attaches to any 2″ post. This listing […]
Learn More
$89.00
+Shipping
Add this 36″ Umbrella Pole to your existing pole and base system to create free standing wind resistant umbrella bases. Use with our Hand Sanitizing Brackets to create an outdoor sanitizing station. Dimensions: 1.90 OD x 36.5″ long steel with silver powder coating. Pole only. includes tension screw for base and 2 tension screws for […]
Learn More
$59.99 $47.99
+Shipping
Single Hand Sanitizer Dispenser mount for use with our Pole and base system or counter install. (additional hardware required) Add a hand sanitizer to our pole and base system along with our Pole Table Mount Bracket (not included) add up to hand sanitizer brackets Single unit only. Dispenser not included. Has space for 11″x11″ graphic. […]
Learn More